....

Add-on devices for IM6/6e electrochemical workstations

in IMPEDANCE SPECTROSCOPY, CYCLIC VOLTAMMETRY, POLARISATION CURVES ...
for BATTERIES, FUEL CELLS, ELECTROLYSIS, ELECTRO PLATING ...

 
 

Power potentiostats and electronic loads today are indispensable tools for applications in fuel cell research, battery research, electrolysis, electro plating and others. The PP-series potentiostats are designed to supply and sink currents up to ±40A at a total power dissipation of up to 200W. The PP-series  potentiostats are controlled by an EPC40 card, a plug-and-play-module which is plugged into an extension slot of the IM6/6e.  Each EPC40 is able to address up to 4 PP/EL devices. Up to four EPC40 cards can be installed in an IM6 system, one in an IM6e system. In total, an IM6 is able to control up to 16 PPs, an IM6e up to 4. Each potentiostat will hold all its values from one control access to the next one so that no potential or current disturbances will occur while scanning a series of potentiostats. If Automatic Series Measurements are performed with more than one PP-series device connected, spectra are taken from all modules in a user-defined order. The PP-series potentiostats are implemented completely in the IM6/6e environment. Thus all acquisition and analysis techniques that run under Thales can be used as well with these modules. The installation of one or more PP will upgrade your IM6/6e to an even more versatile high-current electrochemical workstation.

Web Site Navigation